Review of Sewer Solution [S078-888635]

I have been full timing for 4 years with the Stinky Slinky and for the past month I have been using the Sewer Solution. I have an 09 Allegro Bus which has a black tank flush, so I have 4 hoses with quick connects on two Y-splits with a back flow inhibitor on the hoses that feed the sewer solution and the black water flush with shut off valves nearest the rig to control flow rate. The other Y feeds the freshwater and the back flow Y. I use a 10 clear and 3 bayonet with a 45 degree clear to attach the SS so it is on the outside of the wet bay. The 10 clear allows me to see the flow rate. I have found that once the black water appears empty, I shut the value of 30 seconds, let the flush run, and reopen again and a lot more black water comes out. I repeat this several times until the blackwater is mostly clear. (If a vacuum occurs I open the gray a little.) Then open the gray and leave it open. I put a cup of Pine Sol in the toilet and flush a couple times. The result is very little odor from the black tank until it almost is full. When it is time to pack up I flush the SS for a couple of mins shut it off and pull the rubber out of the dump line and rinse it off with a gentle stream into the dump hole. Put the 10 still attached to SS in a large garbage bag and store it. For cold weather use I'm thinking of using a heat tape...

Rating: [5 of 5 Stars!] by Bob O'Leary